2GIG’s Wireless Smoke/Heat/Freeze Alarm

2GIG’s Wireless Smoke/Heat/Freeze Alarm is a 3xAAA battery‐powered wireless alarm intended for use in a 2GIG system. The alarm has a built‐in wireless transmitter, which communicates with the 2GIG Control Panel. When smoke, excessive heat or cold is detected, the alarm sounds a loud local alarm and the built‐in transmitter sends a signal to the Control Panel. This alarm is designed to provide protection within a 35‐foot radius of the unit. The 2GIG‐SMTK3‐345 can send alarm, tamper and battery condition messages to the Control Panel.

2GIG Wireless Carbon Monoxide Alarm

The Wireless Carbon Monoxide Alarm is intended for use with wireless alarm systems. The detector consists of an electrochemical carbon monoxide sensor assembly coupled to a wireless transmitter. The Wireless Carbon Monoxide Alarm communicates with the Control Panel and can send alarm, tamper and battery condition messages to the system’s receiver.

Monitors for the sound of breaking glass

The Glass Break Detector is a fully-supervised, tamper-protected, ceiling- or wall-mounted unit. It communicates with the 2GIG Control Panel using the 345 MHz frequency. The detector provides a 15 ft (4.6 m) maximum detection range, 360° maximum horizontal sensing angle, and dual-stage glass break detection.

Thin Door/Window Sensor(DW10)

Also available in 120 pc. bulk packs: 2GIG-DW10-120PK

The Thin Door/Window Contact is designed for use on doors, windows, and other objects that open and close. It communicates with the control panel using the 345 MHz frequency. When the magnet (which is mounted near the sensor) moves away from or closer to the door contact’s sensor, signals are transmitted to the control panel.

The 2GIG Doorbell is a dual-purpose doorbell that can be installed with the dwelling’s existing 24 V wiring or using the 345 MHz radio frequency:

Wired Installation. When installed as a wired doorbell with the home’s existing 24 AC wiring, the bell is fully water-resistant and the push button remains illuminated.

Wireless Installation. When installed as a wireless doorbell, it features a fully water-resistant button. It communicates with the control panel using the 345 MHz frequency. The push button does not remain illuminated.

Recessed Door/Window (DW20R)

Also available in 120 pc. bulk packs: 2GIG-DW20R-120PK

The 2GIG Recessed Door Contact is the industry’s most flexible supervised door contact. It communicates with the 2GIG Control Panel using the 345 MHz wireless frequency. It also allows a multitude of applications while hiding the transmitter within a door or window frame.

Bypass Door/Window (DW40)

The bypass contact works for those times you want to open a door without making noise while disarming the system.

The Bypass Door/Window Contact is designed for use on doors that may need to be temporarily bypassed to serve as an entry and exit path to an armed zone.

There is a discreet hidden push button integrated to the top of the case that allows a user to activate the bypass feature—to open and close the door once without having to disarm the alarm panel. A special coded message is sent to compatible receivers that can log this local user bypass event. An integrated LED indicates to the user, the state and status of the bypass feature. For higher security, the bypass push button can be disabled and the contact can be used as a micro sized door window contact without the local bypass feature. A message is sent when the magnet is moved away from the contact and another message is sent when the magnet is replaced near the contact again. It communicates with a 2GIG control panel at the 345Mhz frequency. The contact is equipped with a cover tamper to notify the user if the device has been tampered with. (2GIG panel firmware version 1.14 or higher is required to log the bypass activity.)

Motion Detector (PIR1)

Passive Infrared Motion Detector

The 2GIG Passive Infrared Motion Detector is a wall-mounted unit with wide-angle motion protection. It communicates with the control panel using the 345 MHz frequency. When set to High (HI) Sensitivity Mode, the PIR has a maximum range of 30 ft deep x 50 ft wide (9.1 m x 15.2 m). The PIR’s pet-immune feature can be set to tolerate animals up 55 lbs.

Fully supervised
Lithium battery
ETL listed

Image Sensor for 2GIG GC2

The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also initiate image capture on-demand to peek in on their property. Images are stored locally and uploaded either automatically when motion is captured during alarm events or manually when requested by the user. Once uploaded, images are available for viewing on the Alarm.com Website or an Alarm.com Smart phone app. The sensor is battery powered, all wireless, and simple to install and operate. A system with a 2GIG Cell Radio Module connected to an Alarm.com account with service plan subscription is required.

Flood/freeze Sensor

The Flood/Freeze Sensor is a small device that signals users when water is detected or if the surrounding area’s temperature drops below a set point within two seconds. Due to its small size, the sensor can be placed under sinks, toilets or near hot water tanks making it ideal for high risk areas and reducing the potential of environmental risks.

Panic Button (PANIC1)

Users can mount the panic button in a convenient location.

The Panic Button Remote is a compact, battery powered, wireless panic button that transmits an Emergency signal from any location within radio frequency (RF) range of the control panel. The signal can be transmitted to the control panel, whether the security system is armed or disarmed.

4-Button Keyfob Remote (KEY2)

The 2GIG 4‐Button Keyfob Remote communicates with the 2GIG Control Panel on the 345 MHz frequency. It gives users the ability to turn the security system ON and OFF before entering the home or after exiting. If there is an emergency, you can turn on the siren and automatically call the central monitoring station. Keyfobs can be programmed to operate the programmable output in the Control Panel. Use with the 2GIG Universal Garage Door Receiver (2GIG‐GDR1‐345) to open a garage door. The keyfob is a lithium coin battery‐powered, wireless keyfob designed to fit on a key chain, in a pocket, or in a purse.

Z-Wave Garage Door Opener Remote Controller Accessory

The Garage Door Remote Controller Accessory opens or closes a sectional garage door remotely through a Z-Wave certified Gateway or Security Panel. It is compatible with virtually any automatic garage door opener connected to a sectional garage door.

Smart Plug-in Dimmer Module

The Plug-in Lamp Module is designed to provide Z-Wave control to a connected dimmable lamp. The PD300Z-2 module is plugged into any standard grounded AC wall outlet, and the lamp is then plugged into the module. Once connected, the lamp can be dimmed or turned on or off remotely via the Z-Wave controller. The module contains two power receptacles – one controlled, and one pass-through (powered at all times).

This Plug-in Lamp Module integrates with other Nortek Security & Control Z-Wave enabled products, and can also act as a wireless repeater to ensure that commands intended for another device in the network are received (useful when a device would otherwise be out of radio range).

Auto-Sense

Unique to Nortek Security & Control, the Auto-Sense feature allows for local lamp activation independent of the Z-Wave controller status. With AutoSense, one can simply switch the connected lamp’s manual switch off, then on, and AutoSense will instruct the PD300Z-2 to turn the lamp on.

Smart In-Wall Outlets

The Single Wall Outlet is wired in place of a standard duplex receptacle. This device allows remote ON/OFF control of loads connected to the bottom outlet (the other outlet remains powered at all times). This Z-Wave Outlet enabled products can also act as a wireless repeater to ensure that commands intended for another device in the network are received (useful when a device would otherwise be out of radio range).

Smart In-Wall Switches

The Wall Mount Switch allows remote ON/OFF control of loads connected to the switch, and is easily wired in place of a standard wall switch. This Z-Wave Outlet enabled products can also act as a wireless repeater to ensure that commands intended for another device in the network are received (useful when a device would otherwise be out of radio range).

GC-TBZ48 Z-Wave Programmable Thermostat

Video Monitoring solution allows your customers to see what’s happening at their home or business property when they can’t be there. Video Monitoring integrates seamlessly with your app, or it can be offered independently for customers who only want Video Monitoring.

Indoor IP cameras offer the choice of fixed or pan/tilt viewing, and include built-in 802.11 secure wireless connectivity.

The outdoor IP camera supports Power-Over-Ethernet and ensures that activity around the property is visible, day and night.

Smart Door Locks – Deadbolt

Features

• Z-Wave Kwikset deadbolt
• Fits standard doors (1-3/8″ to 2″) with no new screw holes required
• Customizable access codes
• One-touch locking
• Back-lit keypad
• Alarm sounds after 3 consecutive incorrect codes are entered

Smart Door Locks – Lever

Features

• Z-Wave Kwikset Door Lock
• Fits standard doors (1-3/8″ to 2″) with no new screw holes required
• Customizable access codes
• One-touch locking
• Back-lit keypad
• Alarm sounds after 3 consecutive incorrect codes are entered

Smart Doorbell Camera

The smart doorbell camera is completely integrated into your smart home security system, letting you see who’s at the door whether you’re home or not, have a two-way audio conversation with visitors through your app, and even unlock your front door’s smart lock from the same screen.

Once installed, the smart doorbell also becomes a smart home security camera, able to record and send you motion-detected or doorbell-activated clips, or clips triggered by other devices like your garage door. Its motion sensor can also trigger other devices, such as your porch lighting, to deter potential intruders.

Professionally installed and configured, and completely integrated into your smart home, the Wi-Fi Doorbell Camera is available this spring.

StarLight Cameras for Better Night Vision 2.8-12mm Vari-Focal Lens

This IP-CAMERA (short for IP-CAM) is designed for high performance CCTV solutions. It adopts state of the art video processing chips. It utilizes most advanced technologies, such as video encoding and decoding technology, complies with the TCP/IP protocol, SoC, etc to ensure this system more stable and reliable.

This product is widely used in banks, telecommunication systems, electricity power departments, law systems, factories, storehouses, uptowns, etc. In addition, it is also an ideal choice for surveillance sites with middle or high risks.

Cameras with 2-4mm Motorized Zoom

These cameras feature H.265 main profile video compression technology, high compression ratio and stable stream control.

These cameras support smart analysis of valuables watching, perimeter and abnormal video signal detection as well as defogging, HLC, BLC, digital image stabilization and defect correction to fit different needs.

Supports microSD card local storage, up to 64 GB Supports CVBS local video and two-way audio and PoE power supply.
Supports smart phone, iPad and remote monitoring.

License Plate Reader 4MP 9-22mm

Capture Vehicle Latest Technology high shutter speed with High Resolution Real-time Video.

It features built in Varifocal HD Auto Iris Lens which allow you to adjust the angle of View.

This License Plate Camera is able to capture Vehicle travelling less than 60miles/h (60MPH)

Outdoor/Indoor security and surveillance waterproof & vandal proof camera can clearly capture license plate up to 260FT IR Distance.

4K 8MP 2.8-12mm Vari-Focal Lens

Observe high-quality footage. A wide viewing angle allows you to see more detail and cover more ground to keep more of what you love safe.

Utilize intelligent alerts that send notifications to your computer or smartphone via the Smart Shield Security app. Record events as soon as they happen and store them in the Cloud.

Whether it’s rain or shine, day or night, these Vari-Focal cameras feature heavy-duty, weatherproof housing and vandal-resistant design. With IR night-vision up to 164 feet, you can keep the people and places you love safe 24/7. Always stay in the know by recording at specific times based on your preference.

Indoor and Outdoor Cameras

Video Monitoring solution allows your customers to see what’s happening at their home or business property when they can’t be there. Video Monitoring integrates seamlessly with your app, or it can be offered independently for customers who only want Video Monitoring.

Indoor IP cameras offer the choice of fixed or pan/tilt viewing, and include built-in 802.11 secure wireless connectivity.

The outdoor IP camera supports Power-Over-Ethernet and ensures that activity around the property is visible, day and night.

Indoor/Outdoor Dome Camera Adc-Vc825 from Alarm.com

The ADC-VC825 from Alarm.com is a highperformance fixed dome camera optimized for indoor and outdoor video monitoring. Its discreet, compact design and outstanding HD quality video make the camera ideal for both commercial and residential video installations. The camera features a vandal-resistant exterior casing with an IP66 rating and Power over Ethernet (PoE) capabilities.